This TPA3118 PBTL 12V 24V Power Mono Digital Amplifier Module comes with very good sound quality. The module equips a Mono digital audio power amplifier chip. A large area of copper and dense vias hole enhances heat dissipation. it has current limiting, short circuit, and over-temperature protection..
The TSL235R light-to-frequency converter outputs a square wave (50% duty cycle) with frequency directly proportional to light intensity (irradiance). The device has been temperature compensated for the ultraviolet-to-visible light range of 320 nm to 700 nm and responds over the light range of 320 nm..
A USB/TTL converter based on FT232RL high quality, high-performance USB-to-Serial Bridge Controller. TTL FTDI Transmitter USB for 3.3V/5V Dual power FT232RL MWC Programmer can easily install into your project through a USB interface.
Features:
Automatic detection of data transfer speeds up ..
This is a versatile hardware auto control module that effortlessly converts signals from 3.3V to 5V, ensuring compatibility with a wide range of devices. This converter board is designed with precision and reliability in mind, perfect for industrial applications, automation systems, and other relate..
TTP223 Touch Key Module is based on a touch-sensing IC capacitive touch switch module. A capacitive touch sensor module based on the dedicated TTP223 touch sensor IC. The module provides a single integrated touch sensing area of 11 x 10.5mm with a sensor range of ~5mm.
An onboard LED will give a ..
TTP223B Capacitive Touch Key Sensor Module is based on a touch-sensing IC capacitive touch switch module. It allows you to remove the worry of conventional push-type keys.
Digital Capacitive Touch Switch Module is based on TTP223B. Normally, it outputs low and keeps at a low power state. When a t..
The 4 Channel Capacitive Touch Sensor Module uses the touch-sensing IC TTP224 to sense the touch input thus making it easy to add capacitive touch input to your project. The touching detection IC is designed for replacing the traditional direct button key with a diverse pad size. The module has 4 to..
This is TTP229 16-Way Capacitive Touch Switch Digital Touch Sensor Keypad Module. This capacitive touch sensor module uses the TTP229 integrated circuit, making it easy to add capacitive touch input to your project. It features 16 sensitive touchpads that make an ideal replacement for the old fashio..
This Tube Type Inductive Proximity Sensor Detection Switch NPN DC6-36V 4mm Normally Open switch LJ12A3-4-Z/BX is a component widely used in the automatic control industry for detecting, controlling, and non-contact switching. When the proximity switch is close to some target object, it will send out..
TXB0104 Board is a 4-bit bidirectional voltage-level translator with automatic direction sensing. It features four channels of input/output signals and an output enable line that allows the signal lines to be placed in a high impedance mode when they are unneeded.
Features:
4-Bit Bidirecti..
TXS0108E 8 Channel Bi-Directional Logic Level Converter Module is a small device to convert the 1.8V 3.3V 5V logic level mutually enable you to successfully set your high and low voltages and step up and down between them safely on the same channel. It is a high-speed full-duplex 8 channel logic lev..
This is a GPS module that is based on the Ublox NEO-6M. This unit uses the latest technology from Ublox to give the best possible positioning information and includes a larger built-in 2.5 x 2.5 cm active GPS antenna with a UART TTL socket.
UBLOX NEO-6M GPS Module has a battery for power backup ..