This is a monochrome LCD module comprised of 84x48 pixels that can be used to display rich graphics and text content. Though it's an industrial module, this LCD display is extremely easy to use. This module is a revision that accepts 3-5v input. So no extra level shifter is needed. To have full cont..
The Non-Destructive MP3 Decoding Board with Self-Powered TF Card U Disk Decoded Player module is used for playing tracks in the MP3 format stored on a micro SD card or USB memory. Onboard 2W mono amplifier is connected to the speaker, 3.5mm gold plated headphone jack can connect with headphones or e..
This Normally open vibration sensor module is for a variety of vibration trigger functions, reported theft alarm, smart car, electronic building blocks, and so on. When the product does not shake, the vibration switch is held in off state, the output is high and the green light does not shine and wh..
SDS011 using the principle of laser scattering can get the particle concentration between 0.3 to 10μm in the air. It gives direct digital output via serial protocol at 9600bps and also over 2 PWM channels. There is a built-in fan for stable and reliable operations.
Features:
Accurate and Re..
This wireless Transceiver module is an easy and suitable module if you want to set up your wireless communication system at a low cost!! It can achieve a good balance between wireless transition performance and cost! This module comes with the 2.4G antenna (2DB), with a 250Kbps transmission rate on ..
This module based on Nordic nRF24L01, a highly integrated, ultra-low-power 2Mbps RF transceiver for the 2.4GHz ISM band. Nordic nRF24L01+ integrates a complete 2.4GHz RF transceiver, RF synthesizer, and baseband logic including the Enhanced ShockBurst™ hardware protocol accelerator supporting a hig..
NRF24L01+PA+LNA Wireless Module has an onboard ceramic antenna. It supports six channels of data reception, and 2Mbit/s high-quality VoIP makes it possible, 3.2 MBPS speed when receiving the maximum current of 25mA.
Features:
2.4G Global ISM open G band, maximum 20dBm transmit power.
Stan..
NRF51822 is a powerful, highly flexible multiprotocol SoC ideally suited for Bluetooth, Low Energy, and 2.4GHz ultra-low-power wireless applications.
Features:
Programmable Peripheral Interconnect (PPI)
Independent application development and protocol stack
It is compatible with the NR..
This Wireless Transceiver Module uses a high-performance NRF905 radio chip. It has maximum transmission data rates up to 50Kbps with GFSK, sensitivity to-100dBm.
Features:
NRF905 work band: 433/868/915MHz
Frequency stabilization method: PLL
Anti-interference ability
High reliability, ..
NY-D01 100A Digital Display Spot Welding Controller Board has a Digital Display, you can directly see the time and current. It adopts the principle of silicon-controlled phase shifting triggering to adjust the time and the current to achieve welding.
Features:
Simple and easy to use.
EKW..
The NY-D01 Upgrade 40A Digital Display Spot Welding Time and Current Controller Panel Timing Ammeter Spot Welders Control Board is here to introduce you to the best control for precise spot welding!
Use the NY-D01 Upgrade Controller Panel to increase the precision and efficiency of your spot weld..
OEP8W Digital Power Amplifier Board is not soldered with the input signal cable, and the horn does not have any AC noise.
Precaution:
Make sure the line is connected and then power on.
The speaker cable should not exceed 60CM as much as possible.
Avoid touching the board with static el..