RGB Full Color LED Module has eight pins of D0-D7 which control the eight LEDs respectively, so just connect the digital pins that correspond to Arduino. There are three RGB pins beside it, which need to be connected with GND, bright red with R, bright green with G, bright blue with B, and all three..
HX710B Air Pressure Sensor Module adopts a high-precision AD sampling chip. It has a 0-40KPa air pressure sensor. Pressure Sensors measures fluctuations in the pressure exerted by the atmosphere. It can connect a 2.5mm hose and also can detect water level and other air pressure. It is used for cont..
HX711 Digital Display Electronic Scale Weighing Pressure Module is an integrated module of the pressure sensor test board. The module is connected to the pressure sensor first and then powered on for use. After connecting with the pressure sensor for the first time, calibration is required. The boar..
The I2C ADS1115 16-Bit ADC Module 4 Channel is Your Key to Precision Data Acquisition, and it is available now.
With our ADS1115 ADC Module, you may achieve data measurement projects with unmatched accuracy and adaptability. This 16-bit Analog-to-Digital Converter (ADC) is small, strong, and made..
The four spindles on the ICSH044A Blackberry Trackball Breakout Board 360 Degree Trajectory Ball Module Hall Effect Sensor have a tiny circular magnet in the end; each of these is paired with an SMD hall effect sensor, which is used to measure up, down, left, and right movements of the trackball.
..
IIC/I2C Interface Adapter Module is used for 16×2 LCD Display. It uses the PCF8574T IC chip which converts I2C serial data to parallel data for the LCD display. Also, this interface module simplifies connecting an Arduino to a 16×2 Liquid Crystal display using only 4 wires.
Specifications and Fea..
The Infrared IR Wireless Remote Control Module Kit for Arduino consists of ultra-thin infrared remote control and 38KHz infrared receiver module. This mini slim infrared remote control with 20 function keys. Its transmit distances up to 8 meters. Ideal for handling a variety of equipment indoors.
..
Infrared Obstacle Avoidance Sensor Module is very easy to interface directly with Arduino or other micro-controllers. It also works with the Raspberry Pi with a voltage range of 3-6 volts. It is assembled module with 4 pins. It has an onboard status LED.
Feature:
Four pins: +5-volts, GND, ..
INMP441 MEMS High Precision Omnidirectional Microphone Module has a high signal-to-noise ratio, suitable for near-field applications. It has an I2S interface that allows the INMP441 to be directly connected to digital processors such as DSPs and microcontrollers without the need for an audio codec f..
NodeMCU ESP-8266 WIFI Board CP2102. The Development Kit based on ESP8266 integrates GPIO, PWM, IIC, 1-Wire, and ADC all in one board. Power your development in the fastest way combines with NodeMCU Firmware! R2 version had CP2102 USB-TTL instead, larger current support, the slim board can put on a b..
IP5328P Boost Charging Bidirectional Fast Charging Mobile Power can support a total charging port 4: 2 USB-A output interface, a USB-C interface, Micro USB interface, four interfaces supports fast-charge, wherein two support USB-A port QC3.0, FCP, AFC, MTK, SFCP fast charge output power of up to 18W..
IRF520 MOSFET Driver Module is a breakout board for the IFR520 MOSFET transistor. The module is designed to switch heavy DC loads from a single digital pin of your microcontroller.
Here is a simple breakout board for the IRF520 Mosfet. Easy hookup to your Arduino or another 3-5v microcontroller. ..