It is a high-speed I2C interface temperature sensor. In the temperature range of -55 ℃ ~ + 125 ℃, the temperature was directly converted to digital signals, and to achieve the accuracy of 0.125 ℃. MCU can read data of its internal registers directly via the I2C bus and can operate four registers thr..
CJMCU-811 CCS811 DIGITAL GAS SENSOR is an extremely-low power digital gas detector sensor that incorporates a metal oxide gas sensor to identify a broad range of Volatile Organic Compounds (VOCs) for air quality monitoring with a microcontroller that provides an ADC and an I2C interface.
This ccs..
This is CJMCU 9900 APDS-9900 Digital Proximity And Ambient Light Sensor For Arduino. The APDS-9900 provides digital ambient light sensing (ALS), IR LED, and a complete proximity detection system in a single 8 pin package. The proximity function offers plug and plays detection to 100 mm (without fron..
DC 5V 16Mhz Pro Micro Beetle Keyboard BadUSB USB ATMEGA32U4 Mini Development Expansion Board Module for Arduino Leonardo R3 which has 1x I²C, 1xUART, 1xMicro USB and it has SRAM of 2.5KB and EEPROM of 1KB. This can be used as a USB interface for a virtual keyboard.
Specification:
..
CJMCU-GUVA-S12SD Sunlight Ultraviolet Ray Intensity UV Detection Sensor Module can detect the 240-370nm range of light, detects UV radiation in sunlight. It uses a UV photodiode.
Features:
Low power consumption, the power supply voltage of 2.5 V - 5 V
Good Linear, High sensitivity, and st..
This is Clap Acoustic Control Switch Electronic PCB DIY Kit. The onboard microphone picks up on these noises (claps). When a single clap is detected, a countdown begins, and the device waits for another clap. If another clap is detected within a short period after the first clap, then the relay wil..
This is a supermini Solar Lipo charger based on the CN3065 - a single lithium battery charge management chip. This Solar charger provides you with the ability to get the most possible power out of your solar panel or other photovoltaic device and into a rechargeable LiPo battery. Set-up is easy as w..
MPPT is Maximum Power Point Tracking. This CN3791 12V MPPT Solar Charger Module provides you with the ability to get the most possible power out of your solar panel or other photovoltaic device and into a rechargeable LiPo battery.
The set-up is easy as well, just plug your solar panel into one ..
TCS230 8-pin SOIC surface-mount package, on a single chip,, has 64 photodiodes. These diodes are divided into four types. 16 of the photodiode with a red filter; 16 photodiodes with a green filter; 16 photodiodes with a blue filter; the remaining 16 without any filter, may all the optical informatio..
Colordunio RGB is a specialized RGB full-color dot matrix design a control board module, which in addition to the RGB matrix can be independently driven, but also can be used as a control panel to use Arduino. It pairs the M54564 with a single DM163 constant current driver.
This gives the ATmega3..
Details and Specifications:
This is 10pcs of each (total 30 pcs) jumper cable Dupont wire for Arduino.
High quality and in good working condition.
Durable and reusable.
Easy to install and use.
A popular choice for construction or repair.
Be used for the electronic project and Genuin..
Correlation photoelectric Infrared count slot sensor module is a high-quality infrared Counter module at a very cheap price which comes with tiny size and integrated LM 393 chip.
Features:
The width of the optical coupling slot: 5mm
With a signal output indication.
Single signal output
..