IO Expansion Shield For Arduino Nano is specifically designed to facilitate an easy connection between Expansion Shield For Arduino Nano and many other devices. In essence, it expands for the Arduino Nano controller to link those devices in a simple and trouble-free manner.it will be the Nano all pi..
This Nano Ethernet Shield allows you to connect the Arduino Nano to a network. It is assembled with long stackable pin headers, and don’t need to solder the headers separately.
The Nano Ethernet Shield is based on the ENC28J60 Ethernet chip which provides a network (IP) stack capable of both TCP ..
NE555 Time Delay Monostable Switch with Electrical Relay 12V is a monostable generator based on the NE555 integrated circuit. The power indicator LED and switch trigger timing indication LEDs. Timing from microseconds to long hours.
This is a monostable generator based on the NE555 integrated ci..
NE555 Frequency Adjustable Pulse Generator Module is a Pulse Frequency Duty Cycle Adjustable Module Square Wave Signal Generator. You can choose the output frequency range. The frequency and duty cycle cannot be adjusted independently; changing the duty cycle also affects the frequency. The output s..
NE555 Frequency Adjustable Pulse generator Module utilizes the NE555 timer IC to generate pulses from about 4Hz to 1.3Khz. It generates a square wave signal used for experimental development or driving a stepper motor, it would be also a good choice for users learning& experiencing the analog RC cir..
NEO-8M STM32 C51 MCU GPS Satellite Positioning Module is based on the NEO-8M and can be used for satellite positioning. It has an onboard ceramic antenna, which can easily locate the satellite in an open place without an external antenna. It comes with a micro USB interface, for debugging the GPS mo..
The ESP8266 NodeMCU CH340 board has ESP8266 which is a highly integrated chip designed for the needs of a new connected world. It offers a complete and self-contained Wi-Fi networking solution, allowing it to either host the application or to offload all Wi-Fi networking functions from another appli..
This is a monochrome LCD module comprised of 84x48 pixels that can be used to display rich graphics and text content. Though it's an industrial module, this LCD display is extremely easy to use. This module is a revision that accepts 3-5v input. So no extra level shifter is needed. To have full cont..
The Non-Destructive MP3 Decoding Board with Self-Powered TF Card U Disk Decoded Player module is used for playing tracks in the MP3 format stored on a micro SD card or USB memory. Onboard 2W mono amplifier is connected to the speaker, 3.5mm gold plated headphone jack can connect with headphones or e..
This Normally open vibration sensor module is for a variety of vibration trigger functions, reported theft alarm, smart car, electronic building blocks, and so on. When the product does not shake, the vibration switch is held in off state, the output is high and the green light does not shine and wh..
SDS011 using the principle of laser scattering can get the particle concentration between 0.3 to 10μm in the air. It gives direct digital output via serial protocol at 9600bps and also over 2 PWM channels. There is a built-in fan for stable and reliable operations.
Features:
Accurate and Re..
This wireless Transceiver module is an easy and suitable module if you want to set up your wireless communication system at a low cost!! It can achieve a good balance between wireless transition performance and cost! This module comes with the 2.4G antenna (2DB), with a 250Kbps transmission rate on ..